The SideShot 1 is intended for use with natural draft oil and gas heating equipment. It automatically vents the flue gases from heating equipment to the outdoors. Surrounding combustible surfaces and exhaust gases are kept at safe temperatures by pulling outdoor air into its casing and mixing it with the flue gases during operation. After each burner cycle the SS1 will continue to operate for an adjustable period to purge the heater and vent of residual gases. The SS1 features a 3-way safety system consisting of the UC1 Interlock Control, Fan Proving Switch and High Limit. These devices monitor the SS1 performance and will disrupt the burner if a vent system malfunction is detected. Includes UC1 universal control.
UC1 Control — Interlocks with burner and monitors vent system safeties.
Pressure Switch — Monitors draft and detects outlet blockages.
High Limit — Interrupts burner if the unit casing exceeds safe temperatures.
Weather Protected Operating Components - All mechanical and electrical parts are easily accessible from inside, where they belong, away from potentially damaging cold and wet weather.
Patented High Velocity Exhaust - All gases and soot are propelled by jet action from the the exhaust hood to prevent staining of the building exterior.
Zero Clearance - SideShot vent systems may be installed with zero clearance to combustibles. This feature expands location opportunities including installation between floor joists for above-grade termination.
Verify that the total BTU/hr input of the heating appliance(s) fall within the proper category listed below. Please note the capacity differs between the SS1, SS1C and SS2. To determine equivalent feet, add the total length of straight vent pipe plus 10 feet for each 90 degree elbow and 5 feet for each 45 degree elbow. Vent runs over 15 linear feet should use an approved, insulated vent connector to prevent problems related to condensation. Multiple appliance interlocks require the use of our MAC-Series Multiple Appliance Controls.
The SS1 & SS1C feature a bottom or rear vent connection. The inlet collar accepts any brand or type of 6" diameter vent pipe.
Tip 1: For partial keyword, please use wildcard *. For example b2ta* Tip 2: If you want to find a particular manufacturer, use the "Browse by Manufacturer" feature.
Patriot-Supply.com has spent thousands of dollars and invested countless hours preparing cross references and other information to aid our customers. All information on this website is coded and copyrighted. Any and all information taken illegally will result in litigation.
